Wireless Point to Point (WP2P) RA2 Remote Control System Quick Start Guide
Wireless Point to Point – RA2 – Quick Start Guide – v1.1 – February 2014 2 RA2 - Handheld Remote Control System The RA2 remote control system comprises a WP2P module and a RA2 handheld controller. The RA2 is a small, handheld transmitter that operates up to two outputs of the WP2P module over a range of around 20m. The outputs are controlled from the two buttons labelled “A” and “B”. Multiple RA2s can be used in any system.
Wireless Point to Point – RA2 – Quick Start Guide – v1.1 – February 2014 3 The supplied AAA Alkaline batteries should, under normal usage, provide 3 to 6 months standby operation. The RA2 standby current is approx. 400µA, the transmit current is approx.. 28mA. RA2 Battery Selection Notes The RA2s are battery powered, low power transmitters ideal for short range applications. The quality and capacity of the batteries used has an impact on the life expectancy and range.
Wireless Point to Point – RA2 – Quick Start Guide – v1.1 – February 2014 4 Warning – Do not directly connect to 220V AC voltage. The New Zealand and Australian wiring regulations require that any wiring in excess of 32 volts must be carried out, or be certified by a registered electrician. Consult your local electrical installer for further guidance. Switched Inputs for Lockout Function The inputs (Labelled INP1, INP2 and INP3) are electrically isolated, normally open inputs.
Wireless Point to Point – RA2 – Quick Start Guide – v1.1 – February 2014 5 Using Multiple WP2P Systems in the same area There are ten individual frequency bands referred to as “Channel numbers” allowing up to ten WP2P systems to be used in the same location. The “Channel number” is identified by the “#” on the packaging label; this example is “Channel #1”. Warning – Do not use the same channel for adjacent systems. For example, if you currently use “#1” ensure the adjacent system is “#3” etc.
Wireless Point to Point – RA2 – Quick Start Guide – v1.1 – February 2014 6 User Notes and Installation Details www.qtech.co.
Wireless Point to Point – RA2 – Quick Start Guide – v1.1 – February 2014 7 User Notes and Installation Details www.qtech.co.
