Owner's manual

QTechMultiPointControllerforWP2P-QuickStartGuide–v1–August2012  6
 
www.qtech.co.nz Tel:033663713
I/OLinkEditor–Example1Simple

In this example, when the switch wired to input 1 of the Multi Point Controller is
closed,thefollowinghappens:
 MultiPointControllerOutput1 On
 WP2PModule1Output1  On
 WP2PModule2Output2  On
 WP2PModule3Output3  On
The“Summary”paneontherighthandsideshowsaconfirmationofthemapping.

