Specifications

QSSC-S4R Technical Product Specification BIOS Error Handling
245
Note: for 0048 “Password check failed”, the system halts, and then after the next reset/reboot will displays the error code on the
Error Manager screen.
x Fatal: The system halts during post at a blank screen with the text “Unrecoverable fatal error found. System will not
boot until the error is resolved” and “Press <F2> to enter setup” The POST Error Pause option setting in the BIOS
setup does not have any effect with this class of error.
When the operator presses the F2 key on the keyboard, the error message is displayed on the Error Manager screen,
and an error is logged to the SEL with the error code. The system cannot boot unless the error is resolved. The user
needs to replace the faulty part and restart the system.
Table 168. SEL Format for POST Error Messages
Generator
ID
Sensor T
y
pe
Code
Sensor
number
T
y
pe code E
v
ent Data1 E
v
ent Data2 E
v
ent Data3
33h
(BIOS
POST)
0Fh
(System
Firmware
Progress)
06h
(BIOS
POST
Error)
6Fh
(Sensor
Specific
Offset)
A
0h
(OEM Codes in
Data2 & Data3)
xxh
(Low Byte of
POST Error
Code)
xxh
(High Byte of
POST Error
Code)
Table 169. POST Error Messages and Handling
Error
Code
Error Message Response
0x0012 CMOS Date/Time not set. Major
0x0048 Password check failed. Major
0x0108 Keyboard locked error. Minor
0x0109 Keyboard stuck key error. Minor
0x0113
The SAS RAID firmware cannot run properly. The user should attempt to
reflash the firmware.
Major
0x0140 PCIe Parity Error (PERR). Fatal
0x0141 PCIe resource conflict error. Major
0x0146 PCIe out of resources error. Major
0x0192 Processor cache size mismatch detected. Fatal
0x0193 Processor stepping mismatch. Minor
0x0194 Processor family mismatch detected. Fatal
0x0195 Processor Intel(R) QPI speed mismatch. Major
0x019F
Processor and chipset stepping configuration is unsupported. By continuing
to boot, you acknowledge you are operating in an unsupported
confi
g
uration.
Major
0x5220 CMOS/NVRAM configuration cleared. Major
0x5221 Passwords cleared by jumper. Major
0x5224 Password Clear jumper is set. Major
0x8130 Processor Disabled Major
0x8140 Processor FRB-3 timeout. Major
0x8160
Processor 01 unable to apply microcode update
Major
0x8161
Processor 02unable to apply microcode update
Major
0x8162
Processor 03 unable to apply microcode update
Major
0x8163
Processor 04 unable to apply microcode update
Major
0x8170 Processor Built-In Self Test (BIST) failure. Major
0x8180 Processor microcode update not found. Minor
0x8190 Watchdog Timer failed on last boot. Major
0x8198 OS boot watchdog timer failure. Major
0x8300 Baseboard Management Controller failed self test. Major
0x84F2 Baseboard Management Controller failed to respond. Major