Product guide

Chapter 4: Serviceable Components QSSC-S4R Server System Product Guide
Version 1.0
58
Figure 43. Installing a Power Supply
7. Plug the power cord into the AC receptacle on the power supply. See letter “B” in the figure above.
8. Secure the AC power cord with the power cord clamp.
9. Use the LEDs on the power supply to confirm the power supply is functioning.
Removing and Installing Hot Swap PCI Express Add-in Cards
Note: Cards can be hot swapped only in PCIe slots 1, 2, 6, and 7. The server must be powered down
to install or remove a card from PCIe slots 3 through 5, 8 through 10 and the SAS riser slot. When
looking at the system from the front, slot 1 is on the right.
Removing a Hot Swap PCIe Card
1. Remove the top cover. For instructions, see “Removing the Top Cover” on page 51.
2. Disconnect any cables attached to the card.
3. Press the LED light pipe switch on the PCIe card cover, and wait for the LED to turn off. See letter “A” in the
following figure.
4. Rotate the green retention latch at the top front of the card slot into the up position. See letter “B” in the
following figure.
Figure 44. Removing a hot-swap PCIe card
5. Lift the flap on the PCIe divider. See letter “C” on the following figure.
6. Pull up on the card to remove it. See letter “D” in the figure.