Product guide

Chapter 5: Technician Maintenance QSSC-S4R Server System Product Guide
Version 1.0
118
Replacing the Hot Swap Backplane Board
The Hot Swap Backplane (HSBP) supports up to eight 2.5-inch SATA or SAS drives. The Enterprise SKU
supports all 8 drive connectors available on the hot-swap backplane.
Removing the Hot Swap Backplane Board
1. Remove all hot swap hard drive carriers. For instructions, see “Removing a Hard Drive Carrier” on page 54.
2. Remove the top cover. For instructions, see “Removing the Top Cover” on page 82.
3. Remove all memory dividers and memory risers
4. Remove the memory rug. For instructions, see “Removing the Memory Rug” on page 105.
5. Remove the optical drive. For instructions, see “Removing an Optical Disk Drive” on page 96.
6. Disconnect all cables attached to the Hot Swap Backplane Board (1).
7. Pull the backplane upward to disengage the hooks (2).
Figure 124. Removing the Hot Swap Backplane
8. Lift the hot swap backplane out and away to remove it.
9. Store the hot swap backplane in an anti-static bag.
10. Install the replacement hot swap backplane. For instructions, see “Installing the Hot Swap Backplane Board”
on page 119.