Product guide

QSSC-S4R Server System Product Guide Chapter 5: Technician Maintenance
Version 1.0
85
4. If necessary, remove the expansion slot cover in the slot you are using by sliding it up from inside the
chassis.
Figure 77. Removing a PCIe expansion slot cover
5. Align and slide the adapter board down until it seats in its connector.
6. Press the card down firmly until it seats into the slot.
7. Rotate the retention latch at the rear of the card slot into the down position.
Figure 78. Installing a non- hot swap PCIe Card
8. Attach any required cables to the PCIe card.
9. Install the top cover. For instructions, see “Installing the Top Cover” on page 52.