User manual

Attaching a KLA12 to a KLA181

The KLA12 cannot be attached to the top of a KLA181.

There are various ways to facilitate attaching a KLA12 to a KLA181, and they vary depending on the speciﬁc circumstances. Be sure to use proper

rigging techniques, and/or employ a professional engineer. Following is one example.

Suspend the KLA181 as described in

"Suspending the KLA Array" on page 14, then carefully attach a

KLA12 to the bottom of the KLA181 using the KLA12 attaching mechanism. Continue attaching the remaining

KLA12s to the array.

1. Make sure that levers (1) and slides (2) (on both sides of the KLA12 loudspeaker), are in the positions

shown in

Figure 9 on page 10.

Refer to

Figure 13.

2. Place the top of the KLA12 up to the bottom of the KLA181 such that the front feet on the KLA181 nest into

the feet receptacles on the top of the KLA12. The front and sides of the KLA12 should be aligned with the

front and sides of the KLA181.

Refer to Figure 14

3. On the KLA12 loudspeaker with the hook (2) in the Retracted Position, push button "A" to release

slide

(1). Slide (1) automatically moves upward, and the hook (2) automatically rotates to the Up Position.

In the Up Position, the hook ﬁlls the view hole

(3) in the KLA181.

4. On the KLA12 loudspeaker, pull lever "B" downward to lock the hook

(2) in the Locked Position and

secure the loudspeakers. When the hook

(2) is properly latched, you can only see a portion of the hook

(2) through the view hole (3).

WARNING!: Make sure that the lever "B" locks in the downward, Locked Position indicating that the hook itself is locked. If

the locking mechanism is not properly latched, the loudspeakers could separate and cause physical damage to the loudspeakers,

and/or personal injury.

5. Repeat the procedure for the other side of the loudspeakers, and for all KLA12 loudspeakers in the array. The loudspeakers are ready to suspend.

— Figure 16 —

— Figure 17 —