User manual

10
Mounting the Surface-Mount Back Box
This procedure covers mounting the Surface-Mount Back Box onto an
electrical connection box, and the Mounting Bracket onto the back box.
The Surface-Mount Back Box is designed to be used in conjunction with
an installed, electrical-type, connection box. The back box has several
hole patterns to accommodate multiple connection box types. The
connection box must be no less than approximately 1.5” (38.1 mm) deep
to accommodate the Ethernet connection. This installation method is
primarily intended for new construction projects where the connection
box is installed in the wall with the PoE enabled Q-LAN Ethernet cable
pre-wired to the box. Use the following list and refer to Figure 6 to
determine the proper pattern to use.
1. Australian Pattern, Vertical
2. U.S. Pattern, 2-gang Box
3. German Pattern
4. Australian Pattern, Horizontal
5. U.K. & Swedish Pattern
Refer to Figure 6.
During construction, the electrical connection box must be installed in a
location that provides enough clearance around the Surface Mount Back
Box/TSC-3 to allow for installation of the touchscreen, and the security
screws on the bottom edge of the touchscreen bezel. In addition, the
Ethernet cable should be installed with enough service length to allow
for plugging into the back of the touchscreen.
1. Insert the Ethernet cable through the rectangular opening in the back
box before attaching it to the connection box.
Refer to Figure 7
2. Using the appropriate screwdriver and screws (not included), install
the Surface Mount Back Box onto the connection box.
3. Orient the Mounting Bracket (2) with the flange (3) at the bottom.
4. Use the four Mounting Bracket screws (4) and a screwdriver to
mount the Mounting Bracket (2) to the Surface Mount Back Box (1).
Make sure that the Ethernet cable is fed through the center opening
of the Mounting Bracket.
5. Follow the steps in Mounting the TSC-3 to the Mounting Bracket
page 8.
— Figure 6 —
TOP
1
445 5
1
3
3
33
22
22
— Figure 7 —
1
2
3
4