User manual

10
EN EN
Using the PS-X
For the most part, using the PS-X depends on the configuration of the Page Station in the design created for your installation by your system designer.
To make a page, the Ready LED on the PS-X must be illuminated, then just hold the handheld mic button, and begin talking. Release the button when
you are finished. Review the Page Station documentation, both the user manual and the online help for Page Station configuration.
Identifying the PS-X in Q-Sys Designer
If you have a large number of PS-Xs in your design, it may be difficult to find which component in the design matches a specific piece of hardware.
The way to locate the PS-X is to locate the Page Station to which it is connected.
1. Click the ID button in the Page Station Status component in Q-Sys Designer, or the Page Station in Q-Sys Configurator. The LCD on the associated
Page Station flashes.
Updating Firmware
There is no firmware residing on the PS-X. Firmware updates are made to the Page Station. Refer to the Page Station user manual, or the Q-Sys
Designer online help.