User manual

9
10
Q-Sys™ Core 1000 | Core 3000 | Core 4000 Panel Features
The image below shows the Q-Sys Core 1000, Core 3000 and Core 4000 front panel features for a product having a sample configuration of one blank
I/O Card.
Note that the Q-Sys hardware products are configured at the QSC factory per the customer’s order. At the time of order, the customer specifies the
type of Q-Sys Audio I/O Card to be populated in rear panel audio I/O bay on the Q-Sys Core 1000, Core 3000 and Core 4000 products.
In addition, Q-Sys Audio I/O Card Kits are available for field installation by qualified service personnel.
1 2 3
4
5 6
7 8
9
SD Card Reader Socket1.
Audio I/O Signal and Card Present Indicators2.
240 x 64 Monochrome Graphics LCD3.
Exhaust Vents4.
Next Page Navigation Button5.
Device ID Button (locates device in Q-Sys Designer GUI)6.
Status LED (reports network health, ID and firmware update status)7.
Power On LED8.
Clear Settings Paperclip Button (resets network properties)9.
10. Audio I/O Bay – accepts optional Q-Sys audio I/O cards
11. RS-232 – DE-9 male connector for serial communications
12. Video Out – HD-15 female connector accepts diagnostic
VGA monitor
13. Auxiliary Ports
AUX A Set – USB host connector x2, RJ45 10/100/1000 Mbps Ethernet•
AUX B Set – USB host connector x2, RJ45 10/100/1000 Mbps Ethernet•
14. GPIO A and GPIO B – female DA-15 connectors for Q-Sys control I/O
15. Q-Sys Network Port
LAN A – 1000 Mbps only, primary connection to Q-Sys gigabit network•
LAN B – 1000 Mbps only, backup connection to Q-Sys gigabit network•
16. Reserved for Future Use
17. AC Main Inlet – IEC male connector
11 12 13
10 14 15 16
17
Front Panel
Rear Panel
Q-Sys™ I/O Frame Panel Features
The images below show the Q-Sys I/O Frame front and rear panel features for a product having a sample configuration of two Mic / Line Input Cards
and two DataPort I/O Cards.
Note that the Q-Sys hardware products are configured at the QSC factory per the customer’s order. At the time of order, the customer specifies the
type of Q-Sys Audio I/O Card to be populated in each of the four rear panel audio I/O bays on the Q-Sys I/O Frame.
In addition, Q-Sys Audio I/O Card Kits are available for field installation by qualified service personnel.
1
2 4 5 6
3
87
9
10 11 12
13
Fan Exhaust Vents1.
Audio I/O Signal and Card Present Indicators2.
240 x 64 Monochrome Graphics LCD3.
Next Page Navigation Button4.
Device ID Button (locates device in GUI)5.
Reset Network Properties Paperclip Button6.
Status LED (reports network health, ID and firmware update status)7.
Power On LED 8.
Configurable Audio I/O Bays9.
GPIO Interface (control I/O) (see Page 12)10.
RS-232 Serial Control Interface11.
Dual Gigabit Network Interfaces for Q-Sys LANs12.
AC Main Inlet – IEC male connector13.
Front Panel
Rear Panel