Owner's Manual

7
TD-001572-01-A
Rear Panel
— Figure 6 —
ON
1 2 3
ON
1 2 3
ON
1 2 3
ON
1 2 3
ON
1 2 3
ON
1 2 3
ON
1 2 3
ON
1 2 3
1 2 3
2b
2c 2d 8
4
5
6a 6b
7 2a
1. Signal / Protect / Limit LED (one per channel)
Signal=Green, Limit=Orange, Protect=Red,
Standby=Off
• After 25 minutes with no signal, that
channel will go into standby mode.
2. DIP Switch output configuration (A B – one
pair per channel)
a. 100 V Setting
b. 70 V Setting
c. 8 Ω Setting
d. 4 Ω Setting
3. High-pass Filter – 80 Hz
(On/Off – one per channel)
• High-pass Filter On
• High-pass Filter Off
4. Input – one per channel
• Ground, Negative, Positive
• Balanced / Unbalanced
• 3.5 mm Euro, 3-pin (green)
5. Output – one per channel
• Configurable with DIP switches
• Negative, Positive pins
• 5.0 mm Euro, 4-pin, one for every 2
outputs (green)
• Class 2 Wiring
6. Remote
• Provides remote control of the standby
mode of the amplifier
• Provides indication of standby status of
theamp
• Standby – attach a switch to the two
STBYpins.
» When the switch is open, the amplifier
is not in standby - unless it was put in
standby for another reason.
» When the switch is closed, the
amplifiers in standby.
Not
Standby
Standby
• Relay Contacts
» When the amplifier is operating normally
(passing audio), the relay is energized.
» When the amplifier is in a non-operating
mode (standby etc), the relay is not
energized.
NO
C
NC
Relay
7. Attenuation Knob – (one per channel)
• Attenuates from +4 dBu to infinity (off)
• Use small flat-tip screwdriver to adjust
8. AC Mains
• 100–240 V ~ 50/60 Hz
Not
Standby
Standby