DDI-11 DataPort Accessory Card I N S TA L L AT I O N G U I D E ▼ DDI-11 *TD-000181-00* *TD-000181-00* Preliminary 1
Instructions for the DDI-11 DataPort Accessory Card I. INTRODUCTION VM1 The DDI-11 DataPort Accessory Card is designed for use with QSC amplifiers equipped with a DataPort connector. It provide an easy way to exploit the features of the DataPort without using QSControl or an accessory. +15V Balanced input to Channel 1. IN 2+ Balanced input to Channel 2.
III. INSTALLATION The DDI-11 kit (QSC part # SG-000515-00) includes these items: DDI-11 board Two #4-40 × ¼” black screws Installation guide Use this procedure to install the DDI-11: 1. Turn off the amplifier. 2. Plug the card into the amplifier’s DataPort. Use the two screws on each side of the DataPort to secure it; do not overtighten them. 3. To attach wires to the DDI-11 terminal strip, strip about 5 mm (0.2”) of insulation from the wire.
QSC Audio Products, Inc., 1675 MacArthur Boulevard Costa Mesa, California 92626 USA PH: (714) 754-6175 FAX: (714) 754-6174 QSControl is a trademark of QSC Audio Products, Inc. “QSC” and the QSC logo are registered with the U.S. Patent and Trademark Office.
