User guide

Troubleshoong
61
Power
Power to Solenoids
Green
Solid: Power Supply’s Hi Light is ON [Power to Solenoids and Speaker]
Flashing: MIDI Data Detected - Piano should be playing
Yellow
Solid: Standby: PMII=ON, “Hi” Power=OFF waiting for ON command
Red Solid: Key or Pedal Solenoid Over-Current Shut Down
System
Power to Electronics
Green
Solid: Power Supply’s “Lo” Power LED is ON, PLx initialized.
Yellow Blinks with QRS Remote Control Activity
Network
Green Solid: Stand-Alone Mode [PMII delivers 192.168.1.1 IP Address]
Yellow Solid: Network Mode [PMII gets IP Address from Home Router]
Red Flashing - PMII is not getting an IP Address or not communicating with Wi-Fi
Mode
Music Source
Solid: SD Card or USB Drive [Active after song has been selected]
1 Blink: No SD Card or USB Memory Drive Detected
Green
2
Blinks:
Record Source [Active after song has been selected]
3
Blinks:
Test Files [Active after song has been selected]
Yellow
1 Blink: External: Auxiliary Line In
Solid: External: QRS Controller
3
Blinks:
External: MIDI IN 5-Pin
2
Blinks:
External: MIDI IN USB Client
MIDI
MIDI Data to Solenoids
Green
Solid: Keyscan/Primary 10-pin connection to PNOscan II (Record)
Flashing: MIDI traffic from record system
Red
Solid: No Keyscan/Primary 10-pin connection to PNOscan II (Record)
Flashing: 5-pin MIDI traffic
AMI
Green Solid: Decoding MIDI Data
Yellow
Solid: No MIDI Data detected
Flashing: Audio pass-thru [Including Voice Prompts]
Pin-Light Extension [PLx] Light Patterns
Power System Network Mode MID AM
PLx Button
[Play/Pause/Standby/Reboot]
and IR Remote Sensor
Pin-Light Extension [PLx] Button Functions
Play / Stop
When the 1st light is green…
...press to play the selected song.
...press again to stop playback.
Standby
Press and Hold for 8 seconds…
...yellow lights will can left…
...release when just the 1st light is yellow.
Reboot
Press and Hold for 15 seconds…
...yellow lights will scan left then right
...release when the 1st three lights are yellow.