User guide

Wi‐Fi Setup
53
Select Settings and then Wi-Fi on your iPad, iPhone or iTouch
Select and Connect to the TP-Link
TP-Link_50B880in our example
You may be asked for the TP-Link’s password.
It’s located on the back of the TP-Link.
Set a Static IP address on your iTouch, iPhone or iPad
Touch the blue circle to the right of the TP-Link
Enter the following:
IP address = 192.168.0.5
Subnet mask = 255.255.255.0
Router = 192.168.0.254
DNS = 192.168.0.254
Go back to your home screen…
Select the Safari browser
Enter the following address:
192.168.0.254 and press Go
Enter admin as the User Name and Password
Press the “Log In” button.
Click Quick Setup
Click Next
Select Router Mode
Click Next
Change the SSID to QRSPNO Stand Alone
Set Channel to Auto
Under Security Options: Select Disable Security
Click Next
Under WAN Connection Type select Static IP
Click “Next”
Enter the following:
WAN Connection Type = Static IP
IP address = 192.168.1.5
Subnet mask = 255.255.255.0
Default Gateway = 192.168.1.1
Primary DNS = 192.168.1.1
Secondary DNS = 192.168.0.254
Click Next or Save
Click “Reboot”
Click “OK” to confirm.
The TP-Link will configure and restart.
On the QRS PNOmation II remote control:
Press the following buttons in sequence…
SHIFT FUNC 9 9 0
The third light should be green.
Press SHIFT INFO to confirm the 192.168.1.1 address.
The device is ready for Stand-Alone Mode on the PMII
Connect to the QRSPNO Stand Alone
Open Safari and Navigate to 192.168.1.1
How to Recover the TP-Link: to “Stand Alone: after a TP-Link Reset [iPad & Safari Example]
The TP-Link has been pre-programmed by QRS so it’s not necessary to reset it. But, if the SSID name shown on the back
of the TP-Link appears in your wireless network connection list, it’s been reset. To reset the TP-Link, press and hold the
“Reset” button on the side of the TP-Link for 8 seconds, or until the light blinks at lease 3 times.