User guide

User Guide ‐ Introducon
46
Wirelessly Connect to PMII and Power ON
Check the status of the system by looking at the lights on the PLx box.
If all of the lights are o, the power is probably disconnected
Plug the AC power cord into a wall outlet.
When the piano is plugged into the AC wall outlet….
The lights will scan while the operating system loads and the music is indexed.
Stand By - #1 light is yellow.
No power to move the keys and the speaker is off.
Low Voltage Power - #2 light must be green for the system to operate.
If it’s yellow the system has shut down and you must recycle the power.
Stand Alone Mode- #3 light is green.
All units are shipped from the QRS factory in “Stand Alone” mode.
If #3 light is yellow, and the #2 is green, the system is in Network Mode use a QRS remote to change to Stand-Alone.
Connecting into PMII - Two Steps
1
Wirelessly connect your device to the piano’s Wi-Fi Adapter.
iPod Touch / iPhone / iPad
Go to Settings / Wi-Fi
Select “QRSPNO ####”
Computer [Windows 7 example shown]
Click on your Wireless Network Connection Icon.
Select “QRSPNO ####”
Android
Go to Settings / Wireless Networks / Wi-Fi
Connect to “QRSPNO ####”
Enter 192.168.1.1 or qrspno.local in the address box of your browser window, then refresh the browser.
iPod Touch / iPhone / iPad
Safari
Computer
Use Google Chrome
Android
Press the “Power ON” button.
2
Press the following buttons in sequence…
SHIFT FUNC 9 9 0
The third light should be green.
Press SHIFT INFO to confirm the 192.168.1.1 address.
QRSPNO ###