User guide

33
Mounng & Connecng the Electronic Components
Mount the Power Supply
Having located the sustain pedal solenoid assembly, you can now locate the Power Supply chassis on the side of an
adjacent wooden beam beneath the piano'ssoundboard.You should aempt to locatethe Power Supply chassis  as
closetothebelly‐railaspossiblesoastoavoidexceedingthe
lengthoftherelatedcables.Themounngcanbeplaced
oneitherthewideornarrowsideofthepowersupply.
Mount and Connect the PMII Processor and the Oponal PNOscan (Record)
MounngthenewPNOmaonIIprocessortothepianoandconnectthesecables.
TheDRIVERPORTAsocketMUSTwithin30”oftheINPUTofthefirstDriverBoard.
‐“DRIVERPortA”[Thisisthenewflatblackcablegoingtothedriverboards]
-
“POWERSUPPLY”
[Thisisthe3/4”flatgraycablegoingtothepowersupply]
-
“KEYSCANPRIMARY”‐QRSPNOscanRecordSystemsOnly‐
Blackflatcablecomingfromtherecordsystem’sSo‐Shicircuitboard.
Mount and Connect the Wi‐Fi Adapter and Speaker
PlugthewirelesspoweradapterintoanACoutlet.Therear etwopossiblelocaons:

or
Theun‐switchedoutlet[UNSWOUT]onthetypeApowersupply,ifit’snotbeingused.
 Theextensioncordfromthewalloutletthatrunsinsideorunderthepiano.
Connectthe
EthernetcablefromthewirelesstotheEthernetportonthePMIIprocessor.
UsingtheVelcrostripsupplied,aachthewirelessunittothepia no.
ConnectyourpoweredspeakertothePMII’sAudio#3jack.Usethe1/8”stereo‐to‐RCAcableprovided.
Mounting Brackets
Driver Port A
Power Supply
PNOscan
Silver contact side down
Amplified Speaker
TL‐WR702N