User guide

Mounng & Connecng the Electronic Components
30
Electronic Components ‐ Descripon...
NEW! Driver Board Descripon
TherearefiveKeyNoteDriverBoardsusedinthePianomaonSystem.
Theyareallidencalandcanbeinterchanged,ifnecessary.

NoceInputandOutputconnectors!Inputisnearthe“LogicLED”
“Input”mustbeconnectedtoPMII’sDriverPortAorpreviousdriverboard.
1
 ON/OFFMainPowerSwitch
TheUNSWOUTsocketis“hot”whenswitchisON
2 FUSE:7amp250volt
3 Processor‐RibbonPowerCabletoPMII
4 ACINPUT‐Fromhome’sACOutlet
5 SUSTPEDAL‐ToSustainPedalSolenoid
6 MounngBracket
Canbealsobemounted
totheshortsideofthechassis
7 RAILPWR‐DCPowerHarnesscabletoDriverboards
8 UNSWOUT‐Un‐switchedACOut(ToWi‐Fidevice)
9 FORFUTUREUSE
10 SWOUT‐ToSpeaker
“Hot”onlywhenHIlightisON
11 LO/HIGHvoltLEDs.BothLEDs
mustbeoutbeforecon‐
necngordisconnecngcables
Power Supply Descripon
Do Not connect or disconnect any cables
when the lights are on!
ConnectKeySolenoidstothesesixteen2‐pinconnectors
RibbonCableConnectors/ConnectNoteDriverRibboncables82126,82127&82128
FromPMIIDriverPortAtobassendboardandthenchainotherboardstogether
Fourpinmaleconnector/ConnectNoteDriverPowercable811437‐FromPowerSupplyRail Power
1 2 3 4 5 6 7 8 9 10 11
HighVoltageLight
Low VoltageLight
IndividualnoteLEDs IndividualnoteLEDs
INPUT
OUTPUT
FromPMIIor
previousdriverboard
Tonextdriverboard
LogicLED
Do Not Fold Ribbon Cables!