Installation manual

QRS Music Technologies, Inc. / Technical Support - 800-247-6557 / www.qrsmusic.com
81525i
6
1.42_3 July 7, 2011
Pin-Light Extension [PLx] Features
Green
Steady: HI power LED is ON
Winking: Data to Driver Boards
Yellow
STANDBY
Red Steady: Short Circuit or Low Current State
System
LO power LED
Green
Steady: LO power LED is ON
Yellow Flash: Remote Control Activity
Red
Network
Green Steady: Stand-Alone Mode for Access Point connection
Yellow Steady: Network Mode
Red No Connection
Mode
Green
SD Card [Source & 3] Steady
USB 1 & 2 [Source & 8-9] Steady - should not be same as SD card
Test Files [Source & 12] 3 Blinks then Pause
Internal Demo [Source & 2] 1 Blink per Second
QRS Controller [Source & 1] Steady
AUX In [Source & 4]
Yellow
1 Blink per Second
MIDI In [Source & 5] 3 Blinks then Pause check, QRS remote vs GUI
MIDI
MIDI Traffic to Solenoids
Green
Steady: 10-pin PNOscan
Winking: MIDI traffic
Red Winking: 5-pin MIDI traffic
AMI IN
Green Steady: Decoding MIDI Data
Yellow
Steady Carrier Present
Winking: Audio pass-thru
Reset/Light Intensity Button
Press and hold for 10 seconds to reset system.
Tap and then press and hold to increase/decrease light intensity.
Power
HI power LED
Power System Network Mode MIDI AMI