Installation manual

QRS Music Technologies, Inc. / Technical Support - 800-247-6557 / www.qrsmusic.com
81525i
4
1.42_3 July 7, 2011
4
The Pin-Light Extension serves several functions:
Six lights will display valuable information about your system.
The built-in IR Sensor will allow you to use your existing QRS Remote to control PMII.
USB A, USB Mini B & 1/8” stereo jacks allow you to extend the ports from PMII to an accessible
position on the piano.
The “Reset” button can be use to change the intensity of the lights and to reboot or reset PMII to
factory default values.
Mount the PLx unit to the piano.
We suggest mounting the PLx unit under the keybed at the treble side of the piano.
Installation and Hook-Up of the Pin-Light Extension [PLx]
Connect one end of the 6-pin flat ribbon cable to the PMII’s “ALT” port. The blue side of the cable faces the word “ALT”
Connect the other end of the 6-pin flat ribbon cable to the PLx connector. Connect so the blue side faces the ceiling.
Connect the two USB Male A cables to the USB Host sockets on the PMII.
Connect the other end of the cables to back of the PLx. USBA Male & USB 5-Pin Mini B
Connect one end of a 1/8” audio cable to the PMII’s Audio #1 socket. This is the External Line In [AUX] port.
Connect the other end to the last 1/8” socket of the PLx. See the red line below.
Connect one end of a 1/8” audio cable to the PMII’s Audio #4 socket. This will be used for Headphones.
Connect the other end to the remaining 1/8” socket of the PLx. See the green line below.
Connect to the
back of the PLx.
Front: lights and
reset button
AUX In [Connect to external CD or MP3 player]