Installation manual

QRS Music Technologies, Inc. / Technical Support - 800-247-6557 / www.qrsmusic.com
81525i
2
1.42_3 July 7, 2011
2
Mounting the new PNOmation II processor to the piano.
Slide the two mounting brackets over the ends of the processor.
Snap the retainer clips over each end piece to hold the brackets to the processor.
Place the new processor in the same location as the original.
Position it so that the connectors are easily accessible.
Once you’ve positioned the processor, remove the backing from both brackets to expose the adhesive.
Stick the processor to the piano.
Unclip the brackets, remove the processor and secure the brackets to the piano using the screws provided.
Installation and Hook-Up of the PMII Processor
Mounting Bracket
Clip
Connect the cables to the new PNOmation II processor.
- “DRIVER Port B”
- “POWER SUPPLY”
-
“QRS CONTROLLER” located on the side of the chassis.
It is not necessary to reconnect your original QRS controller.
Driver Port B
Power Supply
QRS Controller
QRS Controller