Installation manual

QRS Music Technologies, Inc. / Technical Support - 800-247-6557 / www.qrsmusic.com
81525i
16
1.42_3 July 7, 2011
1
Turn OFF the player system and unplug the AC power cord from the wall outlet.
Locate the Pianomation processor. It’s within a foot of the QRS power supply.
The power supply is a black box the size of a loaf of bread.
or
On a GRAND piano the processor is mounted to a beam under the soundboard area.
On an UPRIGHT, remove the lower panel to gain access to the power supply.
Flip the ON/OFF switch on the power supply to the “OFF” position.
Disconnect all of the cables from the old Pianomation processor.
Some older processors have different type connectors and use different cables, you may need to replace
cables “A” and “C” below.
Go to http://www.qrsmusic.com/support_hardware.asp “Upgrading Your QRS Pianomation MNIDI System”
for details.
- “TO SOLENOID RAIL” This ribbon cable may be held-in by two small screws.
- “TO POWER SUPPLY”
- “TO CD/USER INTERFACE”
Remove the old Pianomation processor and brackets from the piano by removing the 4 screws.
PMII Upgrade - Remove the Existing Pianomation Processor
Lower
The Power Supply [Type A or B above] and
the Processor are located in these areas.
Type A Type B