Owner's Manual

15 16
Installation
with base
See images

-


Fit the ISOFIX guides with the
ISOFIX anchor points.
The ISOFIX guides can protect
the surface of the vehicle seat
from being torn. They can also
guide the ISOFIX connectors.

Unfold the load leg from
storage compartment.

Line up the ISOFIX connectors
with the ISOFIX guides,
and then click both ISOFIX
connectors into the ISOFIX
anchor points.

Make sure that both ISOFIX
connectors are securely
attached to their ISOFIX
anchor points. There should
be two audible clicks and the
colors of the indicators on
the both ISOFIX connectors
should be completely green.
Check to make sure the
base is securely installed by
pulling on the both ISOFIX
connectors.

After placing the base on the
vehicle seat, extend the load
leg to oor. When the load
leg indicator shows green, it
means it is installed correctly.
When the load leg indicator
shows red, it means the load
leg is in the wrong position.
Make sure the load leg is in
full contact with the vehicle
oor pan.
Squeeze the load leg
releasing button, then shorten
the load leg upwards.
The completely assembled
base is shown as

This infant carrier is suitable
for vehicle seats with i-Size
ISOFIX anchor points with the
Base.
The ISOFIX connectors must
be attached and locked onto
the ISOFIX anchor points.
The load leg must be installed
correctly with green indicator.

Push the infant carrier down
into the base, if the enhanced
child restraint is secure, the
enhanced child restraint
indicator shows green.

Pull up on the infant carrier to
be sure it is securely latched
into the base.

Press the ISOFIX adjustment
button and push the base
back against the vehicle seat
until tight.

To release the infant carrier,
pull the infant carrier up while
pull out the stroller x release
button.

To remove the base, press the
secondary lock button rst
and then the ISOFIX releasing
button on the ISOFIX
connectors before removing
the base from the vehicle seat.
Securing Child
in the Enhanced
Child Restraint
See images

-


While pressing the harness
adjustment button, pull
completely the two shoulder
harnesses of the enhanced
child restraint.

Unlock the buckle of the
harnesses by pressing the red
button.

Do not remove the Head
Support before the baby
sitting.


Infant insert is for children’s
protection. Children under
60cm are suitable to use the
infant insert.


Check that shoulder harness
straps are set at proper height.

Place child into the infant
carrier module and lock the
buckle.


Tighten the shoulder
harnesses by pulling
adjustment webbing.
Installation
without base
See images

-

DO NOT install this infant carrier
module on vehicle seats with Lap
Belts.