User`s manual
SmartRG™ Residential Gateways
Page | 20 Confidential SmartRG © 2012
7. IMPORTANT - Check “Enable Quality of Service” if you intend to support QoS classified
traffic through the WAN service.
8. Click Apply/Save.
NOTE
Enabling QoS for routed IPTV service configurations will improve channel change
performance.
Configuring the Layer 2 Interface (VDSL/PTM)
To configure a VDSL / PTM layer 2 interface:
1. Select Advanced Setup -> Layer2 Interface -> PTM Interface and click Add.
Figure 13 VDSL Layer 2 Interface Configuration
2. Select the “DSL Latency” – Path0 is typical.
3. Select the “PTM Priority” – Normal Priority is typical.
4. Select the “Connection Mode” – Default Mode is typical (when VLAN segmentation is not
required).
5. IMPORTANT - Check “Enable Quality of Service” if you intend to support QoS classified
traffic through the WAN service.