User`s manual

Multi-WAN VPN QoS Router

Priority:

This feature allows users to set the high/low priority of the packet

delivery for the Ethernet port. If it is set as High, the port has the

first priority to deliver the packet. The default value is ―Normal‖.

Speed:

This feature allows users to select the network hardware

connection speed for the Ethernet port. The options are 10Mbps

and 100Mbps.

Duplex Status:

This feature allows users to select the network hardware

connection speed working mode for the Ethernet. The options are

full duplex and half duplex.

Auto Neg.:

The Auto-Negotiation mode can enable each port to automatically

adjust and gather the connection speed and duplex mode.

Therefore, if Enabled Auto-Neg. selected, the ports setup will be

done without any manual setting by administrators.

VLAN:

This feature allows administrators to set the LAN port to be one or

more disconnected network sessions. All of them will be able to log

on to the Internet through the device.

Members in the same network session (within the same VLAN) can

see and communicate with each other. Members in different VLAN

will not know the existence of other members.

VLAN All:

Set VLAN All port to be the public area of VLAN so that it can be

connected to other VLAN networks. A server should be constructed

for the intranet so that all VLAN group can visit this server. Set one

of the network ports as VLAN All. Connect the server to VLAN All so

that computers of different VLAN groups can be connected to this

server. Moreover, the port where the administrator locates must be

set as VLAN All so that it can be connected to the entire network to

facilitate network management.