User`s manual

Multi-WAN VPN QoS Router
62
Example 2:How do I configure Protocol Binding to keep traffic from all Intranet IP addresses
from going through WAN2 when the destinations are IP 211.1.1.1 ~ 211.254.254.254 as well
as the whole Class A group of 60.1.1.1 ~ 60.254.254.254, while traffic to other destinations
goes through WAN1?
As in the following figure, there are two rules to be configured. The first rule: Select ―All
Port [TCP&UDP/1~65535]‖ from the pull-down option list ―Service‖, and then in the boxes
of ―Source IP‖ input ―192.168.1.0 ~ 0‖ (which means to include all Intranet IP addresses).
In the boxes for ―Destination IP‖ input ―211.1.1.1 ~ 211.254.254.254‖. Select WAN2 from
the pull-down option list ―Interface‖, and then click ―Enable‖. Finally, click ―Add New‖ and
the rule will be added to the mode. The second rule: Select ―All Port [TCP&UDP/1~65535]‖
from the pull-down option list ―Service‖, and then in the boxes of ―Source IP‖ input
―192.168.1.0 ~ 0‖ (which means to include all Intranet IP addresses). In the boxes of
―Destination IP‖ input ―211.1.1.1 ~ 60,254,254,254‖. Select WAN2 from the pull-down
option list ―Interface‖, and then click ―Enable‖. Finally, click ―Add New‖, and the rule will be