User`s manual

Multi-WAN VPN QoS Router
60
original numbers ―0.0.0.0‖ in the boxes of ―Destination IP‖ (Which means to include all
Internet IP addresses). Select WAN2 from the pull-down option list ―Interface‖, and then
click ―Enable‖. Finally, click ―Add New‖ and the rule will be added to the mode. The device
will transmit packets to Port 80 through WAN2. However, with only the above rule, packets
that do not go to Port 80 may be transmitted through WAN2; therefore, a second rule is
necessary. The second rule: Select ―All Ports [TCP&UDP/1~65535]‖ from the pull-down
option list ―Service‖, and then input ―192.168.1.2 ~ 254‖ in the boxes of ―Source IP‖. Retain
the original numbers ―0.0.0.0‖ in the boxes of ―Destination IP‖ (which means to include all
Internet IP addresses). Select WAN1 from the pull-down option list ―Interface‖, and then
click ―Enable‖. Finally, click ―Add New‖ and the rule will be added to the mode. The device
will transmit packets that are not going to Port 80 to the Internet through WAN1.
Configuring ―Assigned Routing Mode‖ for load Balance:
IP Group: This function allows users to assign packets from specific Intranet IP