User`s manual

Multi-WAN VPN QoS Router
59
Example 2:How do I set up Auto Load Balance Mode to keep Intranet IP 192.168.1.150 ~ 200
from going through WAN2 when the destination port is Port 80?
As in the figure below, select ―HTTP [TCP/80~80]‖ from the pull-down option list
―Service‖, and then in the boxes for ―Source IP‖ input ―192.168.1.150‖ to ―200‖. Retain the
original numbers ―0.0.0.0‖ in the boxes of ―Destination IP‖ (which means to include all
Internet IP addresses). Select WAN2 from the pull-down option list ―Interface‖, and then
click ―Enable‖. Finally, click ―Add New‖ and the rule will be added to the mode.
Example 3:How do I set up Auto Load Balance Mode to keep all Intranet IP addresses from
going through WAN2 when the destination port is Port 80 and keep all other services from
going through WAN1?
As in the figure below, there are two rules to be configured. The first rule: select ―HTTP
[TCP/80~80]‖ from the pull-down option list ―Service‖, and then in the boxes of Source IP
input ―192.168.1.0‖ to ―0‖ (which means to include all Intranet IP addresses). Retain the