User`s manual

Multi-WAN VPN QoS Router

Service:

This is to select the Binding Service Port to be activated. The

default (such as ALL-TCP&UDP 0~65535, WWW 80~80, FTP 21

to 21, etc.) can be selected from the pull-down option list. The

default Service is All 0~65535.

Option List for Service Management: Click the button to enter

the Service Port configuration page to add or remove default

Service Ports on the option list.

Source IP:

Users can assign packets of specific Intranet virtual IP to go

through a specific WAN port for external connection. In the

boxes here, input the Intranet virtual IP address range; for

example, if 192.168.1.100~150 is input, the binding range will

be 100~150. If only specific Service Ports need to be

designated, while specific IP designation is not necessary, input

―0‖ in the IP boxes.

Destination IP:

In the boxes, input an external static IP address. For example, if

connections to destination IP address 210.11.1.1 are to be

restricted to WAN1, the external static IP address 210.1.1.1 ~

210.1.1.1 should be input. If a range of destinations is to be

assigned, input the range such as 210.11.1.1 ~

210.11.255.254. This means the Class B Network Segment of

210.11.x.x will be restricted to a specific WAN. If only specific

Service Ports need to be designated, while a specific IP

destination assignment is not required, input ―0‖ into the IP

boxes.

Interface:

Select the WAN for which users want to set up the binding rule.

Enable:

To activate the rule.

Add To List:

To add this rule to the list.

Delete selected

application:

To remove the rules selected from the Service List.

Moving Up &

Down:

The priority for rule execution depends on the rule order in the

list. A rule located at the top will be executed prior to those

located below it. Users can arrange the order according to their

priorities.