User`s manual

Multi-WAN VPN QoS Router

connecting with the Internet, or assign all Intranet IP to go through WAN 2 when

connecting with servers with port 80, or assign all Intranet IP to go through WAN 1

when connecting with IP 211.1.1.1, users can do that by configuring ―Protocol Binding‖.

Attention! When the Auto Load Balance mode is collocated with Protocol Binding,

only IP addresses or servers that are configured in the connection rule will follow the

rule for external connections; those which are not configured in the rule will still follow

the device Auto Load Balance system.

Please refer to the explanations in 6.2.3 Configuring Protocol Binding for

setting up Protocol Binding and for examples of collocating router modes with Protocol

Binding.

Exclusive Mode

This mode enables users to assign specific intranet IP addresses, destination application

service ports or destination IP addresses to go through an assigned WAN for external connection.

After being assigned, the specific WAN will only support those assigned Intranet IP addresses,

specific destination application service ports, or specific destination IP addresses. Intranet IP,

specific destination application service ports and specific destination IP that is not configured

under the rules will go through other WANs for external connection. For unassigned WANs, users

can select Load Balance mode and select session or IP for load balancing.

● Session Balance: If ―By Session‖ is selected, the WAN bandwidth will

automatically allocate connections based on session number to achieve network

load balance.

● IP Balance: If ―By IP‖ is selected, the WAN bandwidth will automatically allocate

connections based on the number of IP addresses to achieve network load

balance.

Note!

Only when a device assignment is collocated with Protocol Binding can the

balancing function be brought into full play. For example, an assignment requiring all

Intranet IP addresses to go through WAN 1 when connecting with service port 80, or go

through WAN 1 when connecting with IP 211.1.1.1, must be set up in the Protocol

Binding Configuration.

Attention: When assigning mode is selected, as in the above example, the IP(s) or