User`s manual

Multi-WAN VPN QoS Router

Enable

Line-Dropped

Scheduling:

The WAN disconnection schedule will be activated by checking this

option. In some areas, there is a time limitation for WAN connection

service. For example: the optical fiber service will be disconnected

from 0:00 am to 6:00 am. Although there is a standby system in the

device, at the moment of WAN disconnection, all the external

connections that go through this WAN will be disconnected too. Only

after the disconnected lines are reconnected can they go through the

standby system to connect with the Internet. Therefore, to avoid a

huge number of disconnections, users can activate this function to

arrange new connections to be made through another WAN to the

Internet. In this way, the effect of any disconnection can be

minimized.

Line-Dropped

Period

Input the time rule for the disconnection of this WAN service.

Line-Dropped

Scheduling

Input how long the WAN service may be disconnected before the

newly added connections should go through another WAN to connect

with the Internet.

Link Backup

Interface

Select another WAN port as link backup when port binding is

configured. Users should select the port that employs the same ISP.

Shared- Circuit

WAN

environment

If your WAN connects to a Switch, select ―Enabled‖ to filter broadcast

packets. The default is ―Disabled‖.

MTU:

MTU is abbreviation of Maximum Transmission Unit. ―Auto‖ and

―Manual‖ can be chosen. The default value is 1500. Different value

could be set in different network environment. (e.g. ADSL PPPoE

MTU: 1492)

The default is ―Auto‖.

After the changes are completed, click “Apply” to save the configuration, or click “Cancel"

to leave without making any changes.

PPPoE

This option is for an ADSL virtual dial-up connection (suitable for ADSL PPPoE). Input the user

connection name and password issued by ISP. Then use the PPP Over-Ethernet software built into