User`s manual

Multi-WAN VPN QoS Router

IP Range End:

The four default IP segments end at 192.168.1.149,

192.168.2.149, 192.168.3.149, 192.168.4.149. It means

there are 50 IPs in one of segments. Users can configure

according actual demand.

6.1.3 WAN & DMZ Settings

WAN Setting:

Interface: An indication of which port is connected.

Connection Type: Obtain an IP automatically, Static IP connection, PPPoE (Point-to-Point

Protocol over Ethernet), PPTP (Point-to-Point Tunneling Protocol) or Transparent Bridge.

Config.: A modification in an advanced configuration: Click Edit to enter the advanced

configuration page.

Obtain an Automatic IP automatically:

This mode is often used in the connection mode to obtain an automatic DHCP IP.

This is the device system default connection mode. It is a connection mode in which DHCP clients

obtain an IP address automatically. If having a different connection mode, please refer to the

following introduction for selection of appropriate configurations. Users can also set up their own

DNS IP address. Check the options and input the user-defined DNS IP addresses.