Specifications

Configure Each SpectraLink Wireless Telephone
PN: 1725-36038-001_N.docx 73
If the highlighted power transmit level is legal on all of the
subbands for the set mode, an
All softkey will appear. Press the
All softkey to apply that level to all subbands and return to the
subband menu where all subbands will now be selected.
All
overrides any previously set power transmit levels.
Without subbands: When the 802.11 mode has no subbands, the
Transmit Power list opens when NavOK is pressed to set the
mode. Only those power levels which apply to the domain
and 802.11 mode are listed. Navigate to the desired level and
press
NavOK. This sets the transmit power level and exits the
Regulatory Domain menus. The Network Setup menu will again
display.
Note that the power setting selected specifies the maximum
for that band/subband. When Transmit Power Control (TPC)
is enabled in the infrastructure, the AP may instruct the
handset to use a lower value to match its own transmit power.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. The site
survey starts running immediately upon selecting this option. See the
Diagnostic Tools section for more information about site survey.
Diagnostics Mode
Diagnostics can be enabled or disabled. See Chapter 8 Diagnostic
Tools, section Diagnostics Enabled for a detailed explanation of the
Diagnostics mode options.
Syslog Mode
See Chapter 8 Diagnostic Tools, section Syslog Mode for a detailed
explanation of the
Syslog mode options.
Error Handling Mode
The Error Handling mode determines how the handset will behave
when an error occurs. The
Halt on Error option will cause the handset
to stop operating if an error message is received. Unless the error is a
fatal one, normal operation may be resumed by power-cycling the
handset. The
Restart on Error option will cause the handset to make