User manual

Appendix E PTZ Control Information
1. VioGate-340 supports three types of PTZ control service: Manual Mode, Auto
Mode and Preset Mode.
2. All PTZ protocols support Manual Mode. You can use PTZ control panel on the
bottom left of Monitoring page to control PTZ device of the active channel.
3. If PTZ control mode is set as Auto Mode or Preset Mode, you cannot use PTZ
control panel to control PTZ device on the administration page via IE browser.
4. Only one protocol supports Auto Mode, i.e. DynaColor. PTZ device will rotate
360° automatically in this mode.
5. Some protocols support "Preset mode". In this mode, up to 10 preset
positions can be stored for camera surveillance. Monitoring screen of the
preset positions will be displayed in order. Please refer to the list below for
further information:
Supported PTZ Protocols Information:
Protocol
Name
Interface Baud
Rate
(bps)
Start
Bits
Stop
Bits
Data
Bits
Parity
Check
Manual
Focus
Support
Auto
Mode
Support
Preset
Mode
Support
Computar
YCH-02
RS-485 4800 1 1 8 None Yes No Yes
DynaColor
D7720A
RS-485 9600 1 1 8 None No Yes No
Honeywell
GC-655
RS-485 9600 1 1 8 None No No No
Honeywell
GC-755
RS-485 9600 1 1 8 None No No No
Merit Lilin RS-485 9600 1 1 8 None Yes No Yes
Panasonic
WV-CS564
RS-485 9600 1 1 8 None No No Yes
Pelco
D-Type
RS-485/
RS-422
2400 1 1 8 None
Yes No Yes
Sony
VISCA
EVI-D30
RS-232 9600 1 1 8 None
No No No
VideoTrec RS-485 9600 1 1 8 None No No Yes
VideoTrec
SP-8006W
RS-485 9600 1 1 8 None No No Yes
For the most updated information of supported PTZ protocols, please visit
www.qnap.com.tw.
- 85 -