User manual

• Pan/ Tilt/ Zoom
If the camera connected to VioGate supports P/T/Z function, you can operate
it with the control unit on the monitoring page.
To use P/T/Z function, configure the following settings:
9 Camera ID/ Speed
Select the ID of P/T/Z camera to control and the moving speed of
operation. Camera ID can be 255 at maximum. Speed refers to the
moving speed of PT control unit. The larger the number, the faster the
moving speed. Please refer to the user manual of the camera for further
information.
9 Mode
If manual mode is selected, the camera will stay still and you can control
the angle via the monitoring page. When preset mode is selected, you
can select preset points for PTZ camera. PTZ camera will move
according to each preset position (1-10) every 10 seconds.
9 Protocol
The system supports multiple PTZ protocols: Computar YCH-02,
DynaColor, SONY VISCA, Merit Lilin, Panasonic WV-CS564, Honeywell
GC-655, Honeywell GC-755, VideoTrec, VideoTrec SP-8006W, and Pelco
D-Type.
Note: For further PTZ support information, please refer to Appendix E.
- 38 -