User manual

222
"Get Started Now" to install Symform. The NAS will download, verify, and install the
package automatically. Click "Configure". Enter your email address and click "Sign-In" to
activate Symform on the NAS. An activation code will be sent to this address. Check
your email to get the activation code and finish the setup. Configure Symform
according to the instructions.
When done, the folders chosen during the setup will be backed up to Symform Storage
Cloud. After Symform is activated, you will be able to see the device configuration.
Click "Cloud Dashboard" to have access to Symform Cloud Dashboard and check the
status of all the devices that are running Symform Storage Cloud.
Note about Sym form service:
Web administration interface TCP port: 59234
Contribution TCP port: Defined randomly during Symform setup and can be
changed if necessary.
All TCP outbound ports are mandatory.
The hard drive standby function of the NAS may not work when contribution is in
use, because Symform service always reads and writes data on the hard drives.
Symform with contribution requires network bandwidth. If contribution is enabled,
there will always be communication between the NAS and Symform Cloud. This
may cause network utilization and the bandwidth can be limited as needed.