User manual

425
Ba s ic sy ste m re se t (3 se c )
When you press the reset button for 3 seconds, a beep sound will be heard. The following settings
will be reset to default:
System administration password: admin
TCP/ IP configuration: Obtain IP address settings automatically via DHCP
TCP/ IP configuration: Disable Jumbo Frame
TCP/ IP configuration: If Port trunking is enabled (dual LAN models only), the port trunking mode
will be reset to ‘Active Backup (Failover)’.
System port: 8080 (system service port)
Security level: Low (Allow all connections)
LCD panel password: (blank)*
*This feature is only provided by TS-439 Pro, TS-439 Pro II, TS-459 Pro, TS-509 Pro, TS-559 Pro,
TS-639 Pro, TS-659 Pro, SS-839 Pro, TS-859 Pro, TS-809 Pro, TS-809U-RP, and TS-859U-RP.
A d v a nce d s y s te m re s e t (1 0 se c )
When you press the reset button for 10 seconds, you will hear two beeps at the third and the tenth
seconds. The NAS will reset all the system settings to default as it does by the web-based system
reset in ‘Administration’ > ‘Restore to Factory Default’ except all the data are reserved. The settings
such as the users, user groups, and the network share folders you previously created will be
cleared. To retrieve the old data after the advanced system reset, you may create the same
network share folders on the NAS and the data will be accessible again.