User manual

37
3.2 Network
TC P/IP
(i) IP A d d r e ss
You can configure the TCP/IP settings of the NAS on this page. Click the Edit button ( ) to edit the
network settings. For the NAS which supports two LAN ports, you can connect both network
interfaces to two different switches and configure the TCP/IP settings. The NAS will acquire two IP
addresses which allow the access from two different subnets. This is known as multi-IP setting*.
When using Finder to detect the NAS IP, the IP of Ethernet 1 will be shown in LAN 1 only and the IP
of Ethernet 2 will be shown in LAN 2 only. To use port trunking mode for dual LAN connection, see
section (iii).
* TS-110, TS-119, TS-210, TS-219, and TS-219P provide one Giga LAN port only therefore do not
support dual LAN configuration or port trunking.