User manual

360
For example, when you turn on the NAS with 5 HDD installed, the LCD panel shows:
C
o
n
f
i
g
.
D
i
s
k
s
?
R
A
I
D
5
You can press the ‘Select’ button to browse more options, for example, RAID 6.
Press the ‘Enter’ button and the following message shows. Press the ‘Select’ button to select ‘Yes’ to
confirm.
C
h
o
o
s
e
R
A
I
D
5
?
Y
e
s
N
o
When you execute RAID 1, RAID 5, or RAID 6 configuration, the system will initialize the HDD,
create the RAID device, format the RAID device, and mount it as a volume on the NAS. The
progress will be shown on the LCD panel. When it reaches 100%, you can connect to the RAID
volume, for example, create share folders and upload files to the folders on the NAS. In the
meantime, to make sure the stripes and blocks in all the RAID component devices are ready, the
NAS will execute RAID synchronization and the progress will be shown on ‘Disk Management’ >
‘Volume Management’ page. The synchronization rate is around 30-60 MB/s (vary by HDD models,
system resource usage, etc.)
No te : If a member drive of the RAID configuration was lost during the synchronization, the RAID
device will enter degraded mode. The volume data is still accessible. If you add a new member
drive to the device, it will start to rebuild. You can check the status on the ‘Volume Management’
page.