Operation Manual

823
Changing port settings of NAS and IP cameras
The default HTTP port of NAS is 8080. In this example, the port is changed to 8000.
Therefore, you have to connect to the NAS via http://NAS IP:8000 after applying the
settings.
Then login the network settings page of the IP cameras. Change the HTTP port of IP
camera 1 from 80 to 81. Then change the port of IP camera 2 from 80 to 82.
Next, login the Surveillance Station Pro. Go to “Camera Settings” > “Camera
Configuration”. Enter the port numbers of IP camera 1 and IP camera 2 as 192.168.1.10
port 81 and 192.168.1.20 port 82 respectively. Enter the login name and the password
for both IP cameras.
Besides, enter the WAN IP address (or your domain address on the public network, for
example, MyNAS.dyndns.org) and the port on the WAN for the connection from the
Internet. After finishing the settings, click “Test” to verify the connection.
Go to the configuration page of your router and configure the port forwarding as below:
Forward port 8000 to the LAN IP of the NAS: 192.168.1.60
Forward port 81 to the LAN IP of IP camera 1: 192.168.1.10
Forward port 82 to the LAN IP of IP camera 2: 192.168.1.20
Note: When you change the port settings, make sure remote access is allowed. For
example, if you office network blocks the port 8000, you will not be able to connect to