Operation Manual
60
2.5 Connecting to NAS by Web Browser
To connect to the NAS by a web browser, follow the steps below:
1. Enter http://NAS IP:8080 or use the QNAP Qfinder to find the NAS. Double click
the NAS name, and the NAS login page will open.
Note:
The default NAS IP is 169.254.100.100:8080. If the NAS has been configured to
use DHCP, you can use the QNAP Qfinder to check the IP address of the NAS. Make
sure the NAS and the computer that runs the QNAP Qfinder are connected to the
same subnet. If the NAS cannot be found, connect the NAS to the computer directly
and run the QNAP Qfinder again.
2. Enter the administrator name and password. Turn on the option “Secure
login” (Secure Sockets Layer login) to allow secure connection to the NAS. If a
user without administration right login the NAS, the user can only change the login
password.
Default username: admin
Default password: admin
Note:
If the NAS is behind an NAT gateway, to connect to the NAS by secure login on
the Internet, the port 443 must be opened on the NAT router and forwarded to the
LAN IP of the NAS.