Operation Manual

347
Network slave m ode
A network UPS slave communicates with network UPS master to receive the UPS status.
To set up your NAS with UPS as network slave mode, follow the steps below:
1. Make sure the NAS is connected to the same physical network as the network UPS
master.
2. Select the option “Enable UPS Support”.
3. Select “Network UPS slave” from the “Protocol” drop down menu.
4. Enter the IP address of the network UPS server.
5. Choose between whether the NAS will shut down or enter auto-protection mode
after AC power fails. Specify the time in minutes that the NAS should wait before
executing the option you have selected. After the NAS enters auto-protection
mode, the NAS resumes the previous operation status when the power restores.
6. Click “Apply All” to confirm.
Note: To allow the UPS device to send SNMP alerts to the QNAP NAS in case of power
loss, you may have to enter the IP address of the NAS in the configuration page of the
UPS device.
Behavior of the UPS feature of the NAS:
In case of power loss and power recovery, the events will be logged in the “System