Operation Manual

346
network master mode, plug in the USB cable on the UPS to the NAS and follow the steps
below:
1. Make sure the NAS (the “UPS master”) is connected to the same physical network
as the network UPS slaves.
2. Select the option “Enable UPS Support”.
3. Click “Enable network UPS Support”. This option appears only when your NAS is
connected to the UPS by a USB cable.
4. Choose between whether the NAS will shut down or enter auto-protection mode
after AC power fails. Specify the time in minutes that the NAS should wait before
executing the option you have selected. After the NAS enters auto-protection
mode, the NAS resumes the previous operation status when the power restores.
5. Enter the “IP address” of other network UPS slaves to be notified in the event of
power failure.
6. Click “Apply All” to confirm and continue the setup for the NAS systems which
operate in network slave mode below.