Operation Manual

345
Standalone m ode – SNMP
To operate under SNMP standalone mode, follow the steps below:
1. Make sure the NAS is connected to the same physical network as the SNMP-based
UPS.
2. Select the option “Enable UPS Support”.
3. Select “APC UPS with SNMP management” from the “Protocol” drop down menu.
4. Enter the IP address of the SNMP-based UPS.
5. Choose between whether the NAS will shut down or enter auto-protection mode
after AC power fails. Specify the time in minutes that the NAS should wait before
executing the option you have selected. After the NAS enters auto-protection
mode, the NAS resumes the previous operation status when the power restores.
6. Click “Apply All” to confirm.
Network m aster m ode
A network UPS master is responsible for communicating with network UPS slaves on the
same physical network about critical power status. To set up your NAS with UPS as