Operation Manual

287
4.5 Hardware
Configure the hardware functions of the NAS.
General
Enable configuration reset switch
When this function is turned on, you can press the reset button for 3 seconds to reset
the administrator password and the system settings to default. The disk data will be
retained.
System
Basic system reset
(1 beep)
Advanced system reset
(2 beeps)
All NAS models
Press the reset button for 3 sec
Press the reset button for 10 sec
Basic system reset (3 sec)
After pressing the reset button for 3 seconds, a beep sound will be heard. The following
settings will be reset to default:
System administration password: admin.
TCP/IP configuration: Obtain IP address settings automatically via DHCP.
TCP/IP configuration: Disable Jumbo Frame.
TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port