Operation Manual

280
Service Binding
The NAS services run on all available network interfaces by default. To bind the services
to one or more specific network interfaces (wired or wireless), enable service binding.
Note: The service binding feature is only available for the NAS with more than one
network interfaces (wired and wireless).
The available network interfaces on the NAS will be shown. All the NAS services run on
all network interfaces by default. Select at least one network interface that each service
should be bound to. Then click “Apply”. The users will only be able to connect to the
services via the specified network interface(s).
If the settings cannot be applied, click “Refresh” to list the current network interfaces on
the NAS and configure service binding again.