Operation Manual

20
Alarm Buzzer
The alarm buzzer can be disabled in “Control Panel” > “System Settings” > “Hardware” >
“Buzzer”.
Beep sound
No. of Tim es
Description
Short beep
(0.5 sec)
1
1)The NAS is starting up.
2)The NAS is being shut down (software shutdown).
3)The user presses the reset button to reset the
NAS.
4)The system firmware has been updated.
Short beep
(0.5 sec)
3
The NAS data cannot be copied to the external
storage device from the front USB port.
Short beep
(0.5 sec), long
beep (1.5 sec)
3, every 5
min
The system fan is out of function (TS-119 does not
support smart fan).
Long beep
(1.5 sec)
2
1)The disk volume is going to be full.
2)The disk volume has reached its full capacity.
3)The hard disk drives on the NAS are in degraded
mode.
4)The user starts hard drive rebuilding.
1
1)The NAS is turned off by force shutdown (hardware
shutdown).
2)The NAS has been turned on and is ready.