User manual

219
10.2 Reset Administrator Password and Network
Settings
Note: To reset the NAS by the reset button, the option “Enable configuration reset
switch” in “System Administration” > “Hardware” must be activated.
System Basic system reset
(1 beep)
Advanced system reset
(2 beeps)
All NAS models Press the reset button for
3 sec
Press the reset button for 10
sec
Basic system reset (3 sec)
When you press the reset button for 3 seconds, a beep sound will be heard. The
following settings will be reset to default:
 System administration password: admin
 TCP/ IP configuration: Obtain IP address settings automatically via DHCP
 TCP/ IP configuration: Disable Jumbo Frame
 TCP/ IP configuration: If Port trunking is enabled (dual LAN models only), the
port trunking mode will be reset to “Active Backup (Failover)”.
 System port: 8080 (system service port)
 Security level: Low (Allow all connections)
 LCD panel password: (blank)*
* Applicable to models with LCD panel only.