User manual

127
To set up your network surveillance system by the NAS, follow the steps below:
1. Plan your home network topology
2. Set up the IP cameras
3. Configure the camera settings on the NAS
4. Configure your NAT router (for remote monitoring over the Internet)
1. Plan your home network topology
Write down your plan of the home network before setting up the surveillance system.
Consider the following when doing so:
i. The IP address of the NAS
ii. The IP address of the IP cameras
Your computer, the NAS, and the IP cameras should be connected to the same
router on the LAN. Assign fixed IP addresses to the NAS and the IP cameras. For
example,
 The LAN IP of the home router: 192.168.1.100
 Camera 1 IP: 192.168.1.10 (fixed IP)
 Camera 2 IP: 192.168.1.20 (fixed IP)
 NAS IP: 192.168.1.60 (fixed IP)