User manual

Chapter 8. Install Power Supply Unit

* This section applies to rack mount NAS models only.

 1U Turbo NAS

To install a redundant power supply unit to the 1U Turbo NAS, follow the steps

below.

1. Turn off the NAS.

2. Remove the screw and dummy plate.

3. Insert the power supply unit and push it to the end.

4. Fasten the screw tightly.

5. Turn on the NAS.

Note: To replace a failed power supply unit, turn off the NAS. Then remove the

failed unit safely and repeat steps 3-5 above to install a new power supply unit.