Datasheet

A Digital Notepad & Multimedia Center on Your Private Cloud
34
UPS AC power
UPS
UPS
WiFi Router
Switch
Turbo NAS (UPS Master)
Wi-Fi Router
Turbo NAS (UPS Slave) Turbo NAS (UPS Slave)
AC mains
UPS support
USB signal
detection
USB signal
detection
UPS AC powerUPS AC power
AC mains
AC mains
UPS supporting
SNMP
Ethernet
Ethernet Ethernet
UPS AC powerUPS AC powerUPS AC power
UPS AC power UPS AC power
UPS AC power
UPS AC power
Low power shutdown signal
Multiple NAS units share USB UPS
The network UPS "master" is connected to the UPS via USB cable. If the power fails, the UPS sends a notication to the
network UPS "master" via USB and all the UPS "slaves" are informed by the UPS master via Ethernet. To set your Turbo NAS
as a UPS "slave": connect the UPS and the Turbo NAS by USB, select [NetworkUPS slave], enter the IP address of the master
server, so the slave server will get notication when the power fails.
Step 2: Enter the IP address of the master server
Step 1: Select "Network UPS slave"